Advantech UNO-1170 Manual do Utilizador

UNO-1170A/AEAtom N270 Fanless, DIN-rail Mounted Embedded Automation Computer with 2 x LAN, 3 x COM, 4 x USB, Audio & PC/104+User Manual

UNO-1170A/AE User Manual 2Chapter 1 UNO-1170A/AE Overview1.1 IntroductionUNO-1170A/AE is an DIN-rail mounted Embedded Automation Computer, which pro

3• Shock Protection: IEC 68002-27, CompactFlash: 50G @ Wall mount, half sine, 11ms (Optional, for UNO-1170AE: 20G @ wall mount, half sine, 11ms)• Vi

UNO-1170A/AE User Manual 41.4 UNO-1170A/AE SeriesThere are four products in UNO-1170A/AE series, as listed below:1.5 Chassis DimensionsFigure 1.1: U

5Figure 1.2: UNO-1170AE Chassis Dimensions

UNO-1170A/AE User Manual 6

2Hardware FunctionalitySections include:•UNO-1170A/AE Peripherals•COM1~2: RS-232 Interfaces•COM 3: RS-232/422/485 Interfaces•LAN: Ethernet Connector•P

UNO-1170A/AE User Manual 8Chapter 2 Hardware Functionality2.1 UNO-1170A/AE PeripheralsThe following figures show the connectors on UNO-1170A and UNO

9Figure 2.3: UNO-1170AE Front ViewFigure 2.4: UNO-1170AE Top View

UNO-1170A/AE User Manual 102.2 COM1~COM2: RS-232 InterfacesThe UNO-1170A/AE offers two standard RS-232 serial communication interface port on COM1 an

112.3.4 RS-232/422/485 SelectionCOM3 support 9-wire RS-232, RS-422 or RS-485 interfaces, and you can set corresponding jumpers to select serial ports

UNO-1170A/AE User Manual iiCopyright NoticeThe documentation and the software included with this product are copy-righted 2011 by Advantech Co., Ltd.

UNO-1170A/AE User Manual 122.3.5 Terminal Resistor Setup for RS-422/485 SW3The onboard termination resistor (120 Ohm) for COM3 can be used for long di

132.3.6 RS-485 Auto Flow & RS-422 Master/Slave Mode SW2You can set the “Auto Flow Control” mode of RS-485 or “Master/Slave” mode of RS-422 by usin

UNO-1170A/AE User Manual 142.4 IRQ and Address SettingThe IRQ and I/O address range of COM3 are listed below:• COM3: IRQ10 (Independent IRQ), IRQ5 (S

152.5 LAN: Ethernet ConnectorThe UNO-1170A/AE is equipped with two Realtek RTL8100CL Ethernet LAN controllers that are fully compliant with IEEE 802.

UNO-1170A/AE User Manual 16The USB interface supports Plug & Play, which enables you to connect or disconnect a device whenever you want without t

17 (BH1 is for real time clock, BH2 is for SRAM)

UNO-1170A/AE User Manual 182.14 LED and Buzzer for System Diagnosis (Diag LED)In a “headless application” (an application without a monitor display),

192.15 PCI/104+ Connectors (UNO-1170AE only)UNO-1170AE supports up to two PCI/104+ cards. The cards will be installed on connector noted “CN18 and CN

UNO-1170A/AE User Manual 20

3Initial SetupSections include:• CompactFlash Installation• PC/104+ Card Installation (UNO-1170AE)• Hard Drive Installation • Chassis Grounding• Power

iiiProduct Warranty (2 years)Advantech warrants to you, the original purchaser, that each of its prod-ucts will be free from defects in materials and

UNO-1170A/AE User Manual 22Chapter 3 Initial Setup3.1 CompactFlash Card InstallationThe procedure for installing a CompactFlash card into the UNO-11

233.2 USB Keypro and Keypro Bracket Installation1. Keep the side cover removed and have the USB keypro dongle ready. (Note: Only the upper internal U

UNO-1170A/AE User Manual 242. Insert the USB keypro/dongle into the internal USB connector and place the keypro bracket as shown in the picture. Then,

253.3 Chassis GroundingPlease connect the chassis ground of UNO-1170A/AE with "EARTH". Figure 3.1: Chassis Grounding Connection3.4 Power C

UNO-1170A/AE User Manual 263.5 PC/104+ Card Installation (UNO-1170AE)The procedure for installing a PC/104+ card into the UNO-1170AE is shown as foll

273. Find 2 metal spacer from accessory bag, and screw tight on the location indicated arrow in the below picture. (Note: There were spacers soldered

UNO-1170A/AE User Manual 286. Screw the side cover and the six screws. Now you are done with the PC/104+ card installation.Notes: • When use PC/104+

293.6 Hard Drive installationThe procedure for installing a hard drive into the UNO-1170A/AE is shown as following step.1. Remove the power.2. Unscre

UNO-1170A/AE User Manual 305. Connect the other end of SATA power cable on the board which the arrow indicated in below picture.6. Screw the side cove

313.8 DIN-rail Mounting SetupPlease follow the below steps to mount the UNO-1170A/AE on the DIN-Rail.1. Screw the provided DIN-Rail Kit on the rear s

UNO-1170A/AE User Manual ivCEThis product has passed the CE test for environmental specifications when shielded cables are used for external wiring. F

UNO-1170A/AE User Manual 323.9 Wallmounting SetupPlease follow the below steps to mount the UNO-1170A/AE on the wall.1. Screw the provided Wall Mount

ASystem Settings and Pin Assignments•Board Connectors and Jumpers•RS-232 Serial Port (COM1~2)•RS-232/422/485 Serial Port (COM3)•Ethernet RJ-45 Connect

UNO-1170A/AE User Manual 34Appendix A System Settings and Pin AssignmentsA.1 Interrupt AssignmentsTable A.1: UNO-1170A/AE Interrupt TableInterrupt N

35A.2 Board Connectors and JumpersThere are connectors and jumpers on the UNO-1170A/AE board. The fol-lowing sections tell you how to configure the U

UNO-1170A/AE User Manual 36Figure A.2: Connector & Jumpers (UNO-1170AE)CN9COM1 RS-232 serial port / COM2 RS-232 serial portCN12COM2 RS-232/422/485

37A.3 RS-232 Serial Port (COM1~COM2)Table A.4: RS-232 Serial Port Pin AssignmentsPin Signal Name1DCD2RxD3TxD4DTR5GND6DSR7RTS8CTS9RI

UNO-1170A/AE User Manual 38A.4 RS-232/422/485 Serial Port (COM3)A.5 Ethernet RJ-45 Connector (LAN1~LAN2)Table A.5: RS-232/422/485 Serial PortsPin RS

39A.6 Power Screw Terminal (CN3)A.7 PS/2 Keyboard and Mouse Connector (CN8)Table A.8: Table A.7: Phoenix Power Connector Pin AssignsPin Signal Name

UNO-1170A/AE User Manual 40A.8 USB Connector (CN4)A.9 VGA Display Connector (CN6)Display MemoryWith 64MB share memory, the VGA controller can drive

41A.10 SATA Data Connector Table A.12: SATA DATA Connectors (CN17)Pin Signal Name1GND2A+3A-4GND5B-6B+7GND

vPacking ListBefore setting up the system, check that the items listed below are included. If any item is not, please contact your dealer immediately.

UNO-1170A/AE User Manual 42

AppendixBProgramming the Watchdog TimerAdvantech [W83627] WDT

UNO-1170 A/AE User Manual 44Appendix B Programming the Watchdog TimerBelow are samples of code for controlling the Watchdog Timer function.----------

UNO-1170A/AE User Manual vi14. If one of the following situations arises, get the equipment checked by service personnel:a. The power cord or plug is

vii Table of ContentsContentsChapter 1 UNO-1170A/AE Overview... 21.1 Introduction ...

UNO-1170 User Manual viii3.7 BIOS Setup and System Assignments ... 303.8 DIN-rail Mounting Setup ...

1UNO-1170A/AE OverviewSections include:• Introduction• Hardware Specifications• Safety Precautions• UNO-1170A/AE Series• Chassis DimensionsCHAPTER