Advantech IPC-644 Series Manual do Utilizador descarregar pdf (Página 14)

Chapter 2 System Setup

2.3 Installing the FDD and HDD

The FDD and HDD drive bay is located in the lower deck of

the chassis. The upper deck has to be detached first, in order

to make the lower deck accessible for installation.

Separating the two decks

1. Remove the chassis cover. See Section 2.1 for further

information.

2. Unplug both power supply connectors from the backplane.

3. In order to detach the upper deck, remove the four screws.

Two of the screws are located at the front of the upper

deck, and two at the back.

4. Lift the upper deck out of the chassis.

Installing the FDD and HDD

1. Remove the four screws of the drive bay so that you can

detach it.

2. Detach the two screws on each side of the FDD cover, and

remove the cover.

3. Attach the FDD unit onto the drive bay.

4. Fit the HDD unit onto the drive bay.

5. Connect the power supply cables.

6. Connect both FDD and HDD cables.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Sem comentários

Advantech IPC-644 Series Manual do Utilizador Página 14