Advantech DNS-3200 Manual do Utilizador descarregar pdf (Página 43)

- 41 -

Step 2: You can press the play button to review the recording. If you’re sure this is the recording

you want then choose [File] > [Save as] > [Change] and in the following dialog box

select PCM 8,000 Hz, 8-bit Mono (the only format supported) and click OK.

Step 3: Try to playback this message in [HotLine Alerts] dialog box. Click browse to locate the

file you’ve just recorded and click the [Play] button to play this recording. If a format

other than PCM 8,000Hz, 8-bit mono is selected then an error message will pop up and

you will not be able to play that recording.

[TCP Server]

Allow you to setup VBOX-3200’s TCP server. Enable [Assign IP] option to enable the drop

down list at the right hand side. Select the network card within the drop down list and your

IP address will be displayed in Bind IP. The default port number for TCP server is 3550; you

may assign different port by entering the port number in the [Port:] text column.

[Multicast Server]

Allow you to setup the Multicast server; its operation is similar to the TCP server setup

describes above. The default port number for Multicast server is 365

Note

：

If you are using Dynamic IP, VBOX-3200 will automatically detect the IP Address per

minute and replace IP so as to ensure re-engagement of remote end RemoteView、IP

Multicast、WebCam and RemotePlayback sys

tem.

[HotLine Option]

The HotLine Notice Interval allows you to specify the time interval between each

notification. For example, if the interval time you specified is 5 minutes, then the system will

calls to your phone/pager every 5 minutes if motion still persist. The system will stop

calling when no motions are detected.

[HotLine Attach Audio Message]

You can specify how many times to repeat the audio message when the system notifies you

by Telephone.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 115 116

Sem comentários

Advantech DNS-3200 Manual do Utilizador Página 43