Advantech PCM-9550F Manual do Utilizador descarregar pdf (Página 29)

Chapter 2 Installation 17

2.7 Installing system memory (DIMMs)

You are able to install memory ranging from 16 to 256 MB of

DIMM onto your PCM-9550F/FM/L card. The card provides one

168-pin DIMM socket, which accepts 16, 32, 64, 128 or 256 MB

3.3 V power level EDO/synchronous DIMMs.

2.7.1 Installing DIMMs

The procedure for installing DIMMs is described below. Please

follow these steps carefully. The number of pins are different on

either side of the breaks, so the module can only fit in one way.

DIMM modiles have different pin contacts on each side, and

therefore have a higher pin density.

1. Make sure that the two handles of the DIMM socket are in the

“open” position. i.e. The handles remain leaning outward.

2. Slowly slide the DIMM module along the plastic guides on

both ends of the socket.

3. Press the DIMM module right down into the socket, until you

hear a click. This is when the two handles have automatically

locked the memory module into the correct position of the

socket.

To remove the memory module, just push both handles outward,

and the module will be ejected from the socket.

2.8 IDE, CDROM hard drive connector

(CN16, CN17)

The PCM-9550F/FM/L provides 2 IDE channels which you can

attach up to four Enhanced Integrated Device Electronics hard

disk drives or CDROM to the PCM-9550F/FM/L’s internal

controller. The PCM-9550F/FM/L’s IDE controller uses a PCI

interface. This advanced IDE controller supports faster data

transfer, PID mode 3, mode 4 and UDMA/33.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 153 154

Sem comentários

Advantech PCM-9550F Manual do Utilizador Página 29