PPC-153 User’s Manual 138
7. Unscrew the four screws on the power supply board. The power
supply board can be detached from the plastic housing after
unplugging the cables from the motherboard.
8. Remove the front panel by hand.
9. Unscrew the ten screws on the LCD holding plate to seperate the
plastic housing and LCD holding plate.The LCD inverter can also
be detached by unscrewing the three screws at the bottom (Toshiba
LCD only).
10. Detach the plastic housing.
11. Detach the LCD by unscrewing the four screws located on the each
corners.
12. The touchscreen is stuck on the LCD holding plate by a strongly
double-side adhensive tape. We do not recommend you to remove
it unless the touchscreen is defective and you would like to replace
it.
Note: Because of the modular design of the LCD and
touchscreen, you do not disassemble the whole
system step by step if you would like to replace
the defective LCD or touchscreen. You just start
disassembling the module from the step 8. Then
you can easily remove the LCD and touchscreen
by step 9 to step 12.
Comentários a estes Manuais