
ARK-5280 User Manual 54
Chapter 5 PCI SVGA Setup
5.1 Introduction
The board has an onboard interface. The specifications and features are
described as follows:
5.1.1 Chipset
The ARK-5280 uses a Intel 855GME + 6300ESB chipset for its graphic
controller. It supports LVDS LCD displays, conventional CRT monitors.
5.1.2 Display memory
The 855GME chip with optimized Shared Memory Architecture, sup-
ports up to 64 MB frame buffer using system memory to provide LVDS
mode up to 1280 x 1024 @ 48bpp with frequency range from 25-MHz to
112-MHz. the interface can drive CRT displays with resolutions up to
2048 x 1536 @ 24 bpp 75 Hz.
5.1.3 Display types
CRT and panel displays can be used simultaneously. The board can be set
in one of three configurations: on a CRT, on a flat panel display, or on
both simultaneously. The system is initially set to simultaneous display
mode. If you want to enable the CRT display only or the flat panel display
only, please contact Intel Corporation LTD., or our sales representative
for detailed information.
5.2 Installation of the SVGA Driver
Complete the following steps to install the SVGA driver. Follow the pro-
cedures in the flow chart that apply to the operating system that you are
using within your board.
5.2.1 Installation for Windows 2000/XP
To install SVGA driver for Window 2000/XP, please run the setup wizard
“Intel Extreme Graphic 2” from the CD-ROM. Example of installation is
shown bellow:
Note: Due to Intel not supporting Win98 and Windows
ME drivers, it is not recommended to install
Win98 or Windows ME on ARK-5280 .
Comentários a estes Manuais