Advantech MIC-3369C Guia de Instalação descarregar pdf (Página 134)

Dialogic

System Release 6.1 CompactPCI for Windows

Release Update 134

Dialogic

System Release Software. If you observe this failure, the following steps

can be used to resolve the problem:

1. Change into the Windows System32 directory.

2. Run “regsvr32 atl.dll”.

3. Change into the Dialogic\bin directory.

4. Run “DetectorsProj -service”.

This can be done once the Dialogic

System Release Software installation has

completed with the above error, before rebooting. Since this service is not started

automatically, the above commands can also be done after reboot, but before the

Dialogic

boards are started.

It is only necessary to perform this procedure one time.

3.2.2 Dialogic

DM3 Architecture for CompactPCI on Windows

Configuration Guide

Update to Section 2.4, Media Loads

Because of features introduced in the Service Update, new media loads are available

for the Dialogic

DM/V2400A-cPCI and DM/V4800BC Media Boards. These media

load should be documented in Section 2.4, Media Loads. For information about the

new media loads, see Section 1.10, “New Media Loads for Dialogic

DM/V4800BC

Media Boards Using Special Coders”, on page 36 and Section 1.24, “New Media

Loads for Dialogic

DM/V2400A-cPCI and DM/V4800BC Media Boards”, on page 70

of this Release Update.

Update to Section 2.4.1.1, DM/V, DM/V-A, DM/V-B, and DM/IP Boards

The following information should be added to indicate that some coders are not

supported on the Dialogic

DM/V4800BC Board with certain media loads:

When using the Dialogic

DM/V4800BC Board, the maximum bit rate for standard

play/record with any basic media load type (for example, media load 1B) is 64 Kbps.

The following coders, which are normally part of the standard basic voice media load,

are not supported on the DM/V4800BC Board with any basic media load due to

density considerations:

• Linear PCM, 8 KHz sampling rate, 16-bit resolution (128 Kbps) VOX and WAVE

• Linear PCM, 11 KHz sampling rate, 8-bit resolution (88 Kbps) VOX and WAVE

• Linear PCM, 11 KHz sampling rate, 16-bit resolution (176 Kbps) VOX and WAVE

Update to Section 2.4.1.1, DM/V, DM/V-A, DM/V-B, and DM/IP Boards

In Table 2, Channel Densities by Board and Media Load (Universal), the table

footnote about echo cancellation should be changed as follows:

• Default configuration is EEC (enhanced EC, 32 ms) for CSP supported ML, unless

otherwise indicated or set in the component named [0x2c] in the respective CONFIG file.

You can only change it to a lower EC tail length, by changing the CSP parameter 0x2c03

accordingly in the respective CONFIG file. Conferencing EC, however, will always be 16

ms, regardless of the EC parameter setting.

Update to Section 3.5, [NFAS] Section

The third note about NFAS D channel backup (DCBU) supported only on ISDN NI-2

protocol is incorrect. DCBU is supported on 4ESS, 5ESS, and NI-2.

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 160 161

Comentários a estes Manuais

Sem comentários

Advantech MIC-3369C Guia de Instalação Página 134

Comentários a estes Manuais

Manuais e produtos relacionados com Processadores Advantech MIC-3369C