Advantech MIC-3369C Guia de Instalação descarregar pdf (Página 137)

Dialogic

System Release 6.1 CompactPCI for Windows

Release Update 137

• 3: DMS100 and DMS250

• 4: NTT

• 7: NET5

• 8: DASS2

• 9: DPNSS

• 10: QSIGE1

• 11: QSIGT1

• 12: NI2

3.2.3 Dialogic

IPT Series on Windows

Configuration Guide

Update to Section 3.3, Starting the Dialogic

Configuration Manager (DCM)

In the instructions regarding the Computer Name dialog box for remote DCM, the

following note should be added:

Note: In order to use remote DCM, the local computer (management node) and

remote computer (managed node) must both be running the same Dialogic

software release (for example, System Release 6.1 CompactPCI Windows)

and same build number. If you try to connect to a remote computer with a

different software release or build number, the following message is

displayed:

An incompatible version of the Dialogic(R) System Release

Software is installed on the remote system

and the software releases and build numbers for the two systems are shown.

3.2.4 Dialogic

Global Call Country Dependent Parameters (CDP)

for PDK Protocols Configuration Guide

Update to Chapter 10, Brazil R2 Bidirectional Protocol Parameter Configuration

The CDP_SKIP_A3_AND_A4_PULSE parameter should be added to this chapter as

follows:

CDP_SKIP_A3_AND_A4_PULSE (Inbound)

Description: Specifies when to send ANI after DNIS when overlap sending is

enabled and the Append F flag is disabled. This parameter is valid only if

CDP_OVERLAP_SENDING_ENABLED=1 and CDP_FLAG_APPEND_F=0.

Values:

• 0 [default]: Protocol waits for A3 or A4 pulse and then requests Category before

requesting ANI. This is the default behavior when

CDP_OVERLAP_SENDING_ENABLED=1 and CDP_FLAG_APPEND_F=0.

• 1: Protocol requests ANI immediately after DNIS, without waiting for A3 or A4.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 160 161

Sem comentários

Advantech MIC-3369C Guia de Instalação Página 137